KisanKraft
®
Agricultural Inter-Cultivator
KK-IC-650D
: +91.80. 6835 7800
Page 16 of 49
2.1 Handle frame adjustment
Adjust the height and direction of handle frame by lock hands.
2.2 Weeding depth adjustment
Control the weeding depth by adjusting the height of the resistance rod. Rod going down,
weeding depth decreased; Rod going up, weeding depth increased.
◆
3. Engine start and stop
△
! Attention
Shift lever must be in the neutral gear position
3.1 Shift lever must be in the neutral gear position before starting the weeder.
3.2 Start the Diesel engine following the steps of user manual.
3.3 Engines should run in the low speed (1450-1750r/min) for 2-3 minutes without load.
3.4 Check if the engine runs normally, if abnormal, please turn it off and repair.
△
! Attention
The Intercultivator must running-in before starting
using. Check Chapter VI for running-in method.
◆
4. Operation
4.1 Starting weeder: Clutch bar should be disengaged, and all gear shifting levers should be in
neutral gear position, and then start the engine following the usual manual.
4.2 Running: Put gear shifting handle in the required gear position, clench the clutch handlebar to
make the weeder work/walk.
4.3 Parking:
a) Loosen Clutch handlebar.
b) Put Gear shifting lever to Neutral position.
c) Following the user manual, if need to turn off the engine
△
! Attention
Park the Intercultivator on flatland.
5. Operation attention
△
!
Attention
5.1 When using Intercultivator, you should pay attention to the working situation and sound of
every part, check if the connection is good. There mustn’t be loosed connection. If there is
abnormal situation, please stop the Intercultivator and check.
5.2 Never carry out work with heavy load if Intercultivator has not been used for a long time,
especially the new ones or the repaired ones.