FarmBoy
®
Agricultural Reaper (Baffle Type)
FB-BC-8642 / 8652
FB-BC4-8636
: www.kisankraft.com
: +91.80.22178200
Page 24 of 36
Spark Plug:
Starting failure and misfiring are often caused by
a fouled spark plug. Clean the spark plug and
check that the plug gap is in the correct range.
For a replacement plug, use the correct type
Periodically clean the spark plug and check that
the spark gap is in the correct range.
IMPORTANT
Note that using any spark plugs other than those designated may result in the engine
failing to operate properly or in the engine becoming overheated and damaged.
• To install the spark plug, first turn the plug until it is finger tight, then tighten it a quarter
turn more with a socket wrench.
TIGHTENING TORQUE: 9.8~11.8 N.m
Muffler:
WARNING
Inspect periodically, the muffler for loose fasteners, any damage or corrosion. If any
sign of exhaust leakage is found, do not use the brush cutter and have it repaired
immediately.
Note that failing to do so may result in the engine catching on fire.
Intake Air Cooling Vent:
WARNING
Check the intake air cooling vent and the area
around the cylinder cooling fins after every 25
hours of use for blockage, and remove any waste
which has attached itself to the brush cutter.
IMPORTANT
If waste gets stuck and causes blockage around
the intake air cooling vent or between the cylinder
fins, it may cause the engine to overheat, and that
in turn may cause mechanical failure on the part of
the brush cutter
(1) Cylinder fin
(2) Intake air cooling vent (back)
Storage
Aged fuel is one of major causes of engine starting failure. Before storing the unit, empty
the fuel tank and run the engine until it uses all the fuel left in the fuel line and the
carburetor. Store the unit indoor taking necessary measures for rust prevention.
Transportation
1.
When hand-carrying the product, cover over the cutting part if necessary, lift up the
product and carry it paying attention to the blade.
FarmBoy
®
Agricultural Reaper (Baffle Type)
FB-BC-8642 / 8652
FB-BC4-8636
: www.kisankraft.com
: +91.80.22178200
Page 13 of 36
Assembly
FB- BC-8642 / 8652
Installing Handle:
1.
Loosen the 4bolts on the upper cap and insert
the handles equally. Retighten the bolts.
2.
Put the handle assembly into the bracket and
put the upper cap over it. Tighten the cap
securely.
Connecting Throttle Wire:
1.
Remove the air cleaner cover.
2.
Connect the end of the throttle wire to the
joint on the top of the carburetor.
Connecting Switch Wires:
Connect the switch wires between the engine and
the main unit.
Pair the wires of the same color.
Installing Protection Shield:
Attach the protection shield with the bolts combined
to the shaft tube.
