5
INSTALLATION
INSTALLATION
Intermediate Rail Shade Adjustment
■
Lift intermediate rail on side to be adjusted. This will take the weight off the cord.
■
Use a screwdriver or dime.
➤
Turn screw clockwise to lift that side of the rail.
➤
Turn screw counter clockwise to lower that side of the rail.
➤
Half a revolution is
1
⁄
4
" adjustment (maximum adjustment is
1
⁄
2
").
NOTE:
if adjusting height of a level bottom rail, repeat this process on the opposite side of bottom rail
to maintain level.
Step 4: Operating the Clutch Control Shade
Clutch Control
To Raise and Lower the Shade
■
Pull down on the cord loop to raise and lower.
■
One side of the loop will raise the shade and one side will lower it.
■
If the same cord is continuously pulled after lowering, the shade will begin to rise.
NOTE:
Do not raise shade any higher than it was intended to go. If shade doesn’t raise evenly, in
most cases lowering it completely will allow cords to re-align on the spool.
CAUTION:
The shade will not operate properly unless the cord tensioner is secured. A cord
tensioner installation kit has been included with your shade.
Troubleshooting
If your shade is not operating correctly:
■
First review the guide that came with your control device.
■
Refer to the following troubleshooting procedures for specific solutions for your shade.
If questions remain, please contact Kirsch
®
at
844-KIRSCH2 (844-547-7242).
Problem
The shade will not snap into the installation brackets.
Solution
Check that the installation brackets are aligned and level.
Problem
The shade is hard to raise or lower, or will not raise or lower.
Solution
Shades cannot be forced into tight inside mount window openings. If an inside mount, check that the shade is
installed correctly. Make sure there is clearance between the ends of the shade and the window casement.
Check that the installation brackets are level. Shim to level, if necessary.
If hold-down brackets are used, make sure they have been released.
Make sure the fabric is not caught.
Screw
Hole
Indicator
Line
OPERATION
