11
INSTALLATION
OPERATION
Further Operation and Programming Information
Automation Remote Operation
For information regarding operation and programming of the Automation remote, refer to your
Automation Remote Control Guide
or to the online Automation Step-by-Step Guide.
Automation App Operation
The Automation Hub is required for Automation App operation. For information regarding setup and operation using the
Automation App, refer to the online Automation Step-by-Step Guide.
Resetting the Blind, If Necessary
Calibration Reset
The calibration reset is used to recalibrate the slat’s travel limits.
1. Press and hold the programming button for approximately 6 seconds. The blind will move slightly. Release the programming
button (the light flashes red).
2. The blind will tilt fully in one direction to set the first limit, then tilt in the opposite direction to set the second limit. The slats will
move slightly one more time to indicate the travel limits have been reset.
Resetting Blind Programming
The programming reset erases blind programming from memory, including group assignments, preventing input devices from
operating the blind. The primary use is to correct group and network assignments during installation. The reset does not affect
travel limits or the favorite position.
1. Press and hold the programming button for approximately 12 seconds. The blind will move slightly after 6 seconds, then again
after 12 seconds. Release the programming button (the light flashes red). The light then flashes a series of green and red to
indicate that blind programming is erased from memory.
2. Refer to “Joining a Blind to a Group” above to program the blind to a group.
Complete the Installation
Attach the Corner Clips (If Required)
If the valance came with returns, connect the returns to the valance using the corner clips
provided.
■
■
The notches on the rear of the valance and returns fit into the grooves of the corner clips.
■
■
Slide one end of each clip onto the rear of the valance until the center of the clip aligns with
the edge of the miter cut at each end.
■
■
Slide a return onto each corner clip until its miter is flush against the miter on the valance.
Attach the Valance Splice (If Required)
For valances that are spliced, join the two mitered valance pieces together by sliding the
valance splice clip over the back of the valance where the two halves meet.
Miters Meet
Valance
Valance
Return
(Cross-
Section)
Corner
Clip
Notch
Notch
Miters
Valance
Splice Clip
