TP660 Service Manual
Step 2. Remove the knob and snap ring.
Step 3. Remove the two knob nut and antenna nut.
Step 4. Remove the four screws as shown in the figure below.
Step 5. Insert a flat screw driver into the seal groove of the aluminum bracket, and push it upwards to
remove the zinc cover; push the aluminum bracket backwards to make it out of the shell, and take out
the flex cable from the socket.
Figure 5-5 Figure 5-6
5.5. Disassemble the Main Board from the Chassis
Step 1. Remove the main board screws and PTT, PCB screws.(see figure 5-7)
Step 2. Remove the top waterproof ring and use a soldering iron to solder off the antenna, then the main
board can be separated from the aluminum bracket.
Figure 5-7
Page 14 of 65
Содержание TP660
Страница 1: ...TP660 Service Manual ...
