KIRAMI Original Tiny S, Инструкция по эксплуатации

Страница: 27 / 84

© Kirami Oy, Finland
3 / 11
INSTRUCTIONS FOR USE: Original Tiny ™ hot tubs
INSTALLATION
Making the foundation
It is important to place the tub on an even surface that can bear the whole weight of the tub
(approx. 800kg). The foundation can be evened out e.g. with chips (picture below) or if you want a
more solid foundation, it can be cast of concrete or covered with slabs. When the bottom of the tub
is clearly in the air, it airs well and dries. Ensure that the tub is not covered by grass or hay, as it will
prevent the wood from breathing and will cause rotting.
Since the hot tub wall height is over 85 cm high, you should get a means of ingress (e.g. steps) to
the outside. Or install the hot tub so that the ingress is easily possible e.g. via terrace.
Note possible maintenance operation when selecting the position for the tub. It must be possible to
move the tub wherever necessary, even if it is embedded in a terrace, for example. The guarantee
will not cover any indirect costs, such as removal or construction of terraces.
Water discharge
The water discharge is a 1” female thread on the opposite side of the stove. Where the supplied 1”
valve and a 32 mm hose coupling is installed. Plan the location
of your tub so that the water discharge will not cause any
problems. Guide the water to the side with hoses – hoses with
a 32 mm ID can be used.
Separately you can purchase a middle
drain kit that can be used to move the drain between the tub
and the heater.
Use pipe tape in valve all thread connections about 15 rounds
thickening towards the base of the thread.
Install the valve with the supplied nipple in its place. And the
hose coupling into the valve the same way. Do not
overtighten. Check for leaks when you fill the tub and fix if
necessary.
FIRE SAFETY
27/84
26.03.2020