© Kirami Oy, Finland
4 / 9
INSTRUCTIONS FOR USE: Original Breezy hot tubs
Fastening the stove
External CULT stoves are supplied separately and the stove’s package includes model-specific
instructions and supplies for attaching them. Easy tanks do not have handles, as the stove will be
placed so close to the ground that it is easier to support from underneath. On an even surface,
there should be approx. 20 mm of space for the support below the stove. However, the proper
height of the support should always be checked at the installation site. Any drink trays / cover
plates can be attached to the stove’s handles with screws supplied with the stove. Ensure the
water-tightness and fastening to the tub. A model-specific drink stand / protective panelling series
attached to the stove are available.
Grates
Cult stoves come with a cradle fireplace grate where a single wire tray grate
is installed. An air iron plate is placed on the top shelf to direct the circulation
of air in the upper part of the firebox. The plate in the upper part of the
stove must not be pushed too far so that it prevents the exhaust of the
smoke. It is prohibited to use the stove without these parts. Note that these
parts wear down over time and get bent and their form will change in use.
You can purchase new ones as spare parts when needed.
Chimney
Be careful, the edges of the chimney are very sharp. Use protective
gloves! The chimney is delivered in a separate box and it consists of four
parts (picture on right) and it needs to be assembled. Remove the
protective film from the thermal protection and place the assembled
chimney to the chimney outlet of the stove.
The first use
The water circulation of the stove shall be rinsed by letting plenty of water in from the pipe above,
so that any metal chips from grinding come out. Collect any trash by swiping it off the bottom of the
tub. When you fill the tub, check the fastening pipes of the stove for any leakages.
USE
When filling the tub, note the number of people because people entering the tub will displace the
water when they enter the tub. If there will be many people in the tub, leave the water surface at
the minimum.
In case you are using your own pump for filling the tub, remove the pumping hose after you have
filled the tub. Many pumps do not have a return valve to prevent the water discharge from the tub
when the pumps are switched off. Before filling the tub, check that the bottom plug of the tub is
closed, ensure that the plug is in place after you have some 10 cm of water in the tub.
24/72
05.01.2018
