KIRAMI Comfort Steady, Инструкция по эксплуатации

Страница: 29 / 88

© Kirami Oy, Finland
5 / 11
INSTRUCTIONS FOR USE: Kirami Comfort Steady
Grates
Cube and Macu stoves come with a cradle for grates Macu has one and Cube two
grates on the cradle. Macu stove also has an air iron plate that is placed on the top
shelf to direct the circulation of air in the upper part of the firebox. It is prohibited to
use the stove without these parts. Note that these parts wear down over time and
get bent and their form will change in use. Especially the lifetime of grates gets
shorter if you do not empty the ashes from the heater after every use. You can
purchase new ones as spare parts when needed (image on the right).
The first use
The water circulation of the stove shall be rinsed by letting plenty of water in from the pipe above,
so that any metal chips from grinding come out. Collect any trash by swiping it off the bottom of the
tub. When you fill the tub, check the fastening pipes of the stove for any leakages.
USE
OPERATIONAL ADVICE
If there is a filter connected to the hot tub. It shall be cleaned and dried if possible whenever the
hot tub is emptied.
No manual dosing of chemicals shall be performed while bathers are present in the hot tub.
It is recommended that the means of access (steps) for hot tub should be away from the chimney to
avoid the user touching the chimney by accident.
Water is to be stirred before measurement to mix the hot surface water with the cooler water
below to prevent false readings. This is to be performed before measuring the temperature and
entering the hot tub the water. Safety check of temperature with bather's elbow is also
recommended just before going into the water.
Monitor the water temperature during bathing so that the heating may be adjusted higher or lower
accordingly. Heating need during the actual bathing depends on the tub and surrounding
temperature and wind conditions.
When filling the tub, note the number of people because people entering the tub will displace the
water when they enter the tub. If there will be many people in the tub, leave the water surface at
the minimum.
In case you are using your own pump for filling the tub, remove the pumping hose after you have
filled the tub. Many pumps do not have a return valve to prevent the water discharge from the tub
when the pumps are switched off. Before filling the tub, check that the bottom plug of the tub is
closed, ensure that the plug is in place after you have some 10 cm of water in the tub.
29/88
18.05.2020