VISION 1480 OWNER’S GUIDE
3
Arming & disarming
ARMING
CONFIRMATION CHIRPS
NORMAL ARMING
Close all doors and then LOCK by your factory
keyless remote or by SmartKey door handle
touch.
Hazard lights will flash, doors will lock, and
the siren will chirp 1 time (if Confirmation Chirps are
ON). The Status LED will light for 5s, during which
time all triggers are disabled. Then the Status LED
will start flashing and Ignition, Door, Trunk and Hood
triggers become enabled. The Shock Sensor (and any other
external
sen-
sor) is enabled 5s after the LED starts flashing (10s after you Lock).
SENSOR BYPASS ARMING
This procedure lets you temporarily disable
the Shock Sensor for a single Arming session:
1)
With Ignition OFF, press the Program Switch
twice
.
2)
Within 20s, press
LOCK
on the factory remote to Arm.
The siren will chirp 2 times, and all triggers (door, IG, etc.) will be active
except the shock sensor and any other external sensors
. Note that when you
Disarm and then Arm again normally, the shock sensor will be enabled.
(ON by default)
This procedure lets you enable or disable the
Arm/Disarm chirps. (Note that the siren will
still go off when the 1480 is triggered.)
1)
With Ignition OFF, press the Program Switch
once
.
2)
Within 20s, press
LOCK
on the factory remote to Arm.
The confirmation chirp state has now toggled and the system is Armed. Re
-
peat the above procedure to toggle the confirmation chirp state back again.
1 Push
2 Pushes
LOCK
OFF
OFF
PROGRAMMABLE
