Kioti DK451, Руководство пользователя

Страница: 109 / 150

MAINTENANCE 6-11
1. Remove the oil filter.
2. Put a film of clean engine oil on the
rubber seal of the new filter.
3. Tighten the filter quickly until it con-
tacts the mounting surface.
Tighten filter by hand an additional half
turn only.
4. After the new filter has been replaced,
the engine oil normally decreases a
little. Make sure that the engine oil does
not leak through the seal and be sure
to check the oil level on the dipstick.
Then, replenish the engine oil up to
the prescribed level.
CAUTION
To avoid personal injury:
Be sure to stop the engine be-
fore changing oil filter cartridge.
Allow engine to cool down
sufficiently, oil can be hot and can
burn.
A12O611B
(1) Oil Filter Cartridge
CAUTION
To avoid personal injury:
Be sure to stop the engine before
changing the oil filter cartridge.
Allow engine to cool down suffi-
ciently, oil can be hot and can burn.
It is located to the right of the tractor.
1. Be sure to move a drain pan under the
filter.
2. Remove the oil filter.
3. Place a film of clean transmission fluid
of the rubber seal of the new filter.
REPLACING HYDRAULIC OIL
FILTER
A12O612A
(1) Gauge (2) Oil Filler Plug
(A) Oil Level is Acceptable Within This Range
IMPORTANT
To prevent serious damage to the
hydraulic system, use only a
KIOTI genuine filter.
4. Tighten the filter firmly until it contacts the
mounting surface. Then tighten the filter,
by hand, an additional half turn only.
5. After the new filter is in place , fill the
transmission up with oil to the upper
line of the oil gauge.
6. After running the engine for a few
minutes, stop it and check the oil level
again, add oil to the prescribed level.
7. Make sure that the transmission fluid
doesn’t leak through the seal.