2-7439
Page 4 of 6
F-3984
4-04-06
9.
With overhead hoist, position loader upright pin to
clear mount pin saddle by 1” (see figure 5). Start
tractor engine and move tractor forward until both
loader upright pins come to rest against flat vertical
stop surface of both mounting brackets. Shut off
engine and set brakes and remove key.
10. Lower loader with overhead hoist until both loader
upright pins rest into mount pin saddles. Start tractor
engine and retract lift cylinders, rotating loader
uprights until uprights are fully seated into back of
mount tube saddles (see figure 6).
11. Shut off tractor engine and set parking brakes.
Insert two 1” x 4-7/8” pins (A) and linch pins (B),
which were removed from loader uprights in
instruction 2. Remove hoist chain or strap from
loader boom arms.(Figure 7)
Figure 4
Figure 6
Figure 5
Figure 7
NOTE:
In some cases a small amount of additional
force may be required to insert pins. If necessary,
use a drift and hammer made of non-sparking
material (a shot-filled mallet is recommended) to
seat loader uprights into mount tube saddles.
12. Remove 3/8” cap screws (L) and lock nuts (E) to
temporarily remove anti-rotation pins (M) to remove
shipping brackets (K) (See Figure 3). Discard
shipping brackets (K), retaining anti-rotation pins
and hardware for later reuse when installing bucket
or attachment.
13. Attach tilt cylinder function hoses (color coded blue
and red) to corresponding tractor valve couplers.
14. Start engine and fully extend and retract cylinders
several times to purge air from hydraulic system.
Add additional tractor hydraulic fluid as specified in
tractor operator’s manual to bring level of hydraulic
fluid up to full.
15. Adjust front wheel tread setting or steering stops, if
necessary, to provide a minimum 3/4” clearance
between front tires and any part of loader with lift
cylinders fully retracted and front axle fully
oscillated. Be sure lift cylinder are fully retracted.
Refer to page 1, under preparing tractor. Refer to
tractor operator’s manual for tread setting and
steering stop adjustment procedures.
1"
loader
upright
pin
stop surface
mount tube
saddle
mount pin
saddle
Linch pin
Hitch pin