KINZO 10M950, Инструкция по эксплуатации

Страница: 18 / 44

10M950 18
ENGLISH
Connecting the appliance to the mains
■
To switch the appliance on, proceed as
follows:
- Connect the female connector to the
connection in the appliance.
- Connect the appliance to the mains.
■
To switch off the appliance, disconnect
the appliance from the mains.
Before switching on, make sure
that the female connector has
been fully inserted into the
connection.
CLEANING AND MAINTENANCE
The machine does not require any special
maintenance.
■
Clean the water tank after each use to
prevent deposits. Do not use detergents,
acids or flammable liquids.
Before cleaning the appliance,
remove the plug from the mains
and wait for the appliance to
cool down completely.
TECHNICAL DATA
10M950
Mains voltage V 230
Mains frequency Hz 50
Power input W 2,000
Capacity l 3.0
Weight kg 2.1
GUARANTEE
Refer to the enclosed guarantee conditions
for the terms and conditions of guarantee.
ENVIRONMENT
Should your machine need replacement after
extended use, do not put it in the domestic
waste but dispose of it in an environmentally
safe way.
DECLARATION OF CONFORMITY
Kinzo B.V. declares that the machines:
Steam wallpaper stripper 10M950
have been designed in compliance with the
following standards: EN 60335-1
and
in accordance with the following directives:
73/23/EEC, 89/336/EEC, 98/37/EC
Ede, The Netherlands, June 2004
M. Kinsbergen
Director
Kinzo B.V., Postbus 735, 6710 BS Ede, The Netherlands
IMPORTANT (FOR UK ONLY)
If the moulded 3 pin plug attached to this
unit is damaged and needs replacing, it is
important that it is correctly destroyed and
replaced by an approved BS 1363/5A fused
plug and that the following wiring
instructions are followed.
The wires in this mains lead are coloured in
accordance with the following code:
blue
neutral
brown live
earth
green and yellow
As the colours of the wires in the mains lead
of this unit may not correspond to the
coloured markings identifying the terminals
in your plug, proceed as follows:
- The wire which is coloured blue must be
connected to the terminal which is marked
with the letter N or coloured black.