Kinoton FP 75 E, Руководство по эксплуатации

Страница: 34 / 81

FP 75 E
Issue: 08/2012
24
3 .2 .8 Changing the Film Gate and Sprocket Parts (35 mm / 70 mm)
The following parts can be changed corresponding to the film format:

Pad shoes
of the combined feed
and bottom sprockets
- Removing:
Turn the chuck knob clockwise
and pull out the pad shoe.
- Inserting:
Pre-stress the chuck knob by
turning it clockwise and insert
the pad shoe shaft.
Release the chuck knob when
the pad shoe arrests.
Á
Film gate with aperture
Loosen the knurled screw,
pull out the film gate, push in the
other film gate and
fasten the knurled screw again.
Â
Film pressure skate
Hang in or out the 35 mm or
70 mm film skate
Ã
Lens with arresting tube
- Removing:
Loosen the handwheel (arrow) and pull out the lens together with the arresting
tube.
- Inserting:
Insert the corresponding lens together with the arresting tube and fasten it by
turning the handwheel.
Friction shafts
- Removing:
Loosen the 3 Allen screws and remove the friction shaft.
- Inserting:
Insert the 35 mm or 70 mm friction shaft (do not forget to add the distance disk
when inserting the 35 mm film shaft. Then fasten the Allen screws again.
Set
toggle switch
on the operating panel to select the desired film format and
restart the projector.
2
1
4
3
1