9
A)
Circular Output Connector:
Provides electrical power to the lamp
head with the use of a 4Bank extension cable.
B)
DMX-In & DMX-Out:
DMX-IN receives DMX signals from Dimmer
Board. DMX-OUT relays DMX signal through to other Fixtures or
Instruments.
C)
Fuse:
Provides circuit protection.
Note: If Fuse is "blown" or
"open" replace with same type of fuse rating as marked.
D)
DMX TERMINATE Switch
: Terminates DMX signal at the end of
Fixture series.
E)
Individual Lamp / Fixture Switch
: Converts between INDIVIDUAL
LAMP and FIXTURE methods of DMX control.
F)
DMX Address:
Sets DMX Address of Fixture.
G)
Lamp Select:
Set to
4ft
for 4ft lamps and
2ft
for 2ft or 15” lamps.
H)
Manual Switches:
Turns lamps on and off manually.
A
E
F
G
H
B
D
C
Lamp Select feature continued…
When operating 4ft lamps in high ambient temperature or where the
units are rigged into place with restricted airflow, the
2FT
setting can
be used to lower the color temperature and remove any green spike.
The light drops about a half an f-stop in exposure when dropping from
4FT
to
2FT.
It is not recommended to operate 2ft lamps in the
4FT
setting. At the
4FT
setting, the color temperature of the 2ft lamps will rise
dramatically and experience a high green spike.
