ENGLISH
DT REaDER HaRDwaRE INSTaLLaTIoN INSTRucTIoNS
The DT Reader is a USB Flash drive with an onboard SD/MMC expansion slot. When inserted into a USB
port, two drive letters (i.e. G:\ and H:\) will appear. One for DT Reader’s internal memory and one for the
expansion slot. Learn more at:
www.kingston.com/support/install/dt.
Inserting and removing SD/MMC media:
1. Open
memory card cover (# 1).
2. Insert media into
memory card slot (# 3);
contacts facing down. To
remove media, use the eject tab
(#2).
3. Close card cover for protection.
Inserting the strap (Optional):
1. Feed the strap
(# 4)
through the hole on the side of the USB cap.
2. Feed the strap through the hole on the side of the DT Reader.
3. Create a loop with the strap and insert the USB cap into the opening.
4. Tighten the strap by pulling on the USB cap.
#1
#2
#3
Inserting the media into the DT Reader:
1. Open the
memory card cover (# 1)
.
2. Insert the MMC/SD media into the
memory card slot (# 3);
contacts facing down.
3. Close the memory card cover for protection.
Removing the media from the DT Reader:
1. Open the memory card cover.
2. Use the
eject tab (# 2)
to remove the media from the memory card slot.
The DT Reader is a standard USB flash drive with onboard SD/MMC expansion. When
inserted into the computer’s USB port, the DT Reader will be assigned two drive letters
(i.e. G:\ and H:\). One drive letter will be assigned to the DT Reader’s internal memory,
and another drive letter will be assigned to the onboard SD/MMC expansion slot.
# 4
Inserting the strap (Optional):
1. Feed the strap (# 4) through the hole on the side of the USB cap.
2. Feed the strap through the hole on the side of the DT Reader.
3. Create a loop with the strap and insert the USB cap into the opening.
4. Tighten the strap by pulling on the USB cap.
DT Reader Hardware Installation Instructions
v1.5
