3.
Use fine point tips only when necessary. The
plating on fine precision tips is less durable
than the plating on blunter tips.
4.
Do not use the tip as a prying tool. Bending the
tip can cause the plating to crack, shortening tip
life.
5.
Use the minimum activation flux necessary to
do the job. Higher activation flux is more
corrosive to the tip plating.
6.
Extend tip life by switching the system off
when not in use.
7.
Don’t apply pressure to the tip. More pressure
does not equal more heat. To improve heat
transfer, use solder to form a thermal
bridge between the tip and the solder joint.
Error Messages
Various error messages will be display when there is a problem with the unit. If the following
message is displayed, see the trouble shooting guide.
Sensor Error
Note
Heater Error
If there is a possibility of a failure in the sensor or
anywhere in the sensor circuit, will be
displayed and power to the soldering iron will be
cut off.
If power is being sent to soldering iron and the tip
temperature goes below the setting temperature
about 80
℃
, the temperature display will flash.
Draw your attention to this.
If power can
’
t be sent to soldering iron, the display
window will show . This indicates the
possibility of a heater malfunction.
Flash the Temperature Display
S - E
S - E
H - E
H - E
