4. Automatic Mode (advanced mode)
11
12
This mode is the advanced mode with higher difficulty. After starting, user can con-
trol the speed completely without the remote control. We only recommend those
who have good sports skills or running experience to take the challenge.
Lifting up Handrail, Maximum speed is 9km/h, which is suitable for running
Pulling down the handrail, maximum speed is 6km/h, which is suitable for walking.
Automatic Mode
4. Learn How to Use the Treadmill
In the automatic mode, when
you run on the belt and quicken
the footsteps (or trot in place),
the Treadmill will accordingly and
gradually accelerate until the
speed is same as the footstep
frequency; when you slow down
the footsteps, the Treadmill will
accordingly and gradually
decelerate until the speed is
same as the footstep frequency.
When the speed is decelerated
below 2.5km/h, the Treadmill will
automatically stop.
Note: Both the automatic
acceleration and deceleration
need to go through the learning
course and adaptation. Some
users will not be adapted to it at
the beginning, but will control
more naturally after getting
familiar with it.
5. Remote Control Notice
If the remote control has no response or you change
the remote control, you need to pair it again.
Pairing mode:
Restart the power, press and hold mode key on the
remote control for 5 seconds, don’ t release until you
hear the “click--” sound, which indicates pairing is
successful.
KS symbol flashing: APP not connected.
KS symbol normally on: APP connected.
6. Introduction to the status display
7. Error Warning Light
Error Warning Light on the display panel is off when "Walkingpad" works
well. When error occurs, Error Warning Light turns on and shows its
error code.
8. Networking and firmware upgrading
OTA firmware upgrading: in the "KS Fit APP" you may receive the
updating prompt. Please view the updating introduction, and operate on
your mobile phone according to the prompt to automatically complete the
firmware upgrading.
E01: Software overcurrent.
E02: Hardware overcurrent.
E03: IPM module overheat.
E04: Undervoltage protection.
E05: Overvoltage protection.
E06: Motor phase loss protection.
Mode key
Single Press: Switch to the automatic mode;
Press And Hold for more than 2 seconds: unlock the
Treadmill.
Start/Stop
Single Click: Start or stop the Treadmill;
Press and Hold: For more than 2 seconds: unlock the treadmill.
Manual Mode
Automatic Mode
E07: Motor locked-rotor protection.
E08: Motor start failure.
E09: Motor overcurrent protection.
E10: Overload protection.
E11: HALL signal loss.
E12: Communication problem.
