8
Log Assembly
Log Assembly
1. Remove logs from carton (4) and inspect.
2. Rear log should be installed onto rear log holder attached to back of
firebox above and to the rear of the burner pan.
3. Front log should be placed and centred on log supports in front of
burner.
4. Spread supplied rocks on bottom pan in front and sides of front log
to give ash appearance. DO NOT PLACE ROCKS ON TOP OF
BACK BURNER.
5. Top logs can then be placed across the front and back logs in the
slots provided.
6. Purge lines and test pilot operation.
7. Optional glass door may now be installed, see page7.
Fresh Air Kit Installation
A Fresh Air Kit may be required by some building codes, remove cover
plate on the bottom side of unit and insert three inch flex duct into the
side of fireplace by screwing it into the hole provided, attach the other
end to the plastic wall vent. When possible place the plastic vent below
the bottom of the fireplace (as shown in diagram).
5.0”