10
8. INSTALLATION
NOTE: INSTALLATION AND REPAIR SHOULD BE
P E R F O R M E D B Y A Q U A L I F I E D S E R V I C E
P E R S O N . T H E A P P L I A N C E S H O U L D B E
I N S P E C T E D B E F O R E U S E A N D AT L E A S T
A N N U A L LY B Y A P R O F E S S I O N A L S E R V I C E
PERSON. MORE FREQUENT CLEANING MA Y BE
REQUIRED DUE TO EXCESSIVE LINT FROM
CARPETING, ETC. IT IS IMPERATIVE THAT THE
C O N T R O L C O M PA RT M E N T, B U R N I N G A N D
C I R C U L AT I N G A I R PA S S A G E WAY S O F T H E
APPLIANCE BE KEPT CLEAN.
Install the fireplace insert in the following order:
1. Clean and inspect chimney.
2. Plan layout of gas line.
3. Plan layout of electrical.
4. Install the chimney liner as instructed in
SECTION
9
.
5. Clean out and vacuum the solid fuel fireplace.
Make sure that the fireplace is completely
cool and has not been used for a few days.
6. Make sure that the solid fuel fireplace base is
level and if not make any necessary adjustments.
7. Slide unit into place attaching draft hood and or
chimney liner as required.
8. Hook up gas line.
9. Hook up electrical.
10. Remove glass by removing two screws behind
upper grill and lifting door off bottom door retainer
(glass is very fragile).
11. Log Installation:
-
Remove logs from carton (4) and
inspect.
-
Install as per Log Placement Guidelines
and set ups.
-
Purge lines and test pilot operation.
12. Ember Kit Instructions:
Spread supplied rock evenly on the bottom of the
fireplace (DO NOT PLACE ROCK ON BURN-
ERS), next tear ember wool into small thin pieces
and place evenly over front burner .
13. Re-install the glass door.
14. Check for correct operation
(See SECTION
10
)
15. Install Surround and Grills as per
instructions.
16. Gas fired appliances may be used only for sup-
plemental heat and/or decorative purposes and
under no circumstances shall they provide a pri-
mary heat source.
(Figure 4)
NOTE: DO NOT BLOCK THE SIDES OR
TOP OF THE APPLIANCE AS THIS WILL AFFECT
THE PROPER AND SAFE
OPERATION OF THE UNIT.
C5 Log