STEP-II
Fit the MIDDLE LEG onto the SEAT FRAME, secure the MIDDLE LEG and SEAT FRAME
with the bolt and Allen key provided and carefully set off to the side. Gently lay the END
FRAME with the stamps near the mortise holes on a clean, flat surface and fit the BACK
SLATS into the END FRAME mortise holes as shown in the above photographs. Carefully
line up and fit the BACK SLATS into the MIDDLE LEG holes while adding the SEAT
assembly to the END FRAME (we recommend a second person help with this step). If
necessary, gently rock the parts while pushing down on them until all the joints fit snugly
together.
STEP-III
Carefully fit the rest of the BACK SLATS into the
MIDDLE LEG mortise holes and fit the remaining
END FRAME mortise holes over all exposed
tenons. Using a rubber mallet or a regular hammer
with the sanding block between the hammer and the
wood, gently drive all the mortise holes onto the
tenons until all joints fit snugly together.
