1
. Disconnect from the mains supply before
proceeding with the installation.
2
. These products should be connected to a lighting
circuit or fused at a maximum of
5
A.
3
. The transformer incorporated in these products has
an isolating
20VA
loading and an output of
230V
and
115V
on the dual voltage version and
230V
on
the single.
4.
Please check with the manufacturers instructions
for suitability with rechargeable shavers.
These units must be mounted horizontally on a
vertical surface. Please read the instructions fully
before attempting installation and retain for future
reference.
1.
Remove the diffuser by gently pressing the sides at
the point indicated, in Fig.
1
, and lift out.
2.
Remove the
60
watt
284
mm tube by gently pushing
it sideways into the right hand or left hand socket
and removing it from the sockets See Fig.
2
3. R
emove the back plate of the shaver light and using
a template mark fixings in the required position on
the wall, and drill fixing holes accordingly.
4
. Connect the cable by passing through the hole in
the back plate and follow the codes as listed:
Live (L) = Brown or Red, Neutral (N) = Blue or
Black, conductor size
0.5
mm to
1.5
mm solid or
stranded, ensure that no strands of cable are visible
outside the connector.
5.
Place shaver light into position with black plate
secured and screw into wall with appropriate
screws through the holes in the base of the unit.
6.
Replace the lamp and diffuser.
7.
Switch back on the mains supply and shaver light is
now ready for use.
Before plugging in the shaver, select the correct out
put voltage (
230
or
115
) with the switch provided
(dual voltage version only).
SAFETY AND INSTALLATION
INSTRUCTIONS FOR
BATHROOM SINGLE & DUAL
VOLTAGE SHAVER LIGHT
- Model No. A
4
N
SAFETY INSTRUCTIONS
INSTALLATION INSTRUCTIONS
Fig. 2
Fig.1
IMPORTANT
This unit should be installed to current IET wiring
regulations, if in doubt consult a qualified electrician.
A4N instructions Aug14.qxp_Layout 1 07/11/2014 11:42 Page 1
