UHF Gain
Control
Combination
VHF/ UHF
Antenna
Power Supply
with Injector
To Amplifier
To TV
VHF Gain
Control (KMW32FS/KMD24FS only)
PSK06F
INPUT
14 VOL
T DC
TV SET OR VCR
PLUG INTO
WALL PLATE
17.5 V AC OR 14 V DC
MASTHEAD AMPLIFIER
SHORT CIRCUIT
PROTECTED
F
TO
F
MALE
ADAPTOR
2M CABLE
TV SET OR VCR
PLUG INTO
WALL PLATE
SHORT CIRCUIT
PROTECTED
2M CABLE
17.5 V AC OR 14 V DC
MASTHEAD AMPLIFIER
UHF Gain
Control
Power Supply
with Injector
To Amplifier
VHF Antenna
UHF Antenna
To TV
VHF Gain
Control (KMW32FS/KMD24FS only)
Switch for Combination
or Separate installations
Lid (open)
Flip amplifier 90º
from housing to allow
access to switch
NOTE:
There is a small switch located in between the input connectors underneath the
sheilding. This will need to be switched to separate when two antennas are used. The left
input should then be connected to the UHF antenna whilst the right input (middle connector)
should be connected to the VHF antenna.
Connect power supply to wall plate as shown below
PSK06F/08F
PSK06/08
All these models are designed for combined or separate antenna inputs
Combined Input
Separate Input
View looking into trhe bottom of the housing
1.
Check:
There is no earth braid touching
the centre conductor on the coaxial cable.
2.
Is there more than one outlet?
Check
the splitter box, the power supply must be
connected to the coaxial outlet that feeds
the AC/DC leg of the splitter box to pass
power to the head unit.
(Check if LED is on).
3.
If there is a white line moving through
the picture:
Try a PSK06 14 V DC power
supply.
4. Adjust gain control on amplifi er to achieve
correct signal levels to digital receiver.
TECHNICAL ADVICE
SPECIFICATIONS
This warranty against defects is given by
Standard Communications Pty Ltd ACN 000 346
814 (We, us, our or GME). Our contact details
are set out in clause 2.7. This warranty statement
only applies to products purchased in Australia.
Please contact your local GME distributor
for products sold outside of Australia. Local
distributor details at www.gme.net.au/export.
1. Consumer guarantees
1.1 Our goods come with guarantees that
cannot be excluded under the Australian
Consumer Law. You are entitled to a
replacement or refund for a major failure
and for compensation for any other
reasonably foreseeable loss or damage.
You are also entitled to have the goods
STANDARD COMMUNICATIONS CONTRACT WARRANTY
AGAINST DEFECTS
KMW32FS
KMD24FS
KMU32FS
FREQUENCY RANGE
VHF 44-230 MHz
UHF 520-820 MHz
VHF 174-230 MHz
UHF 520-820 MHz
VHF 44-230 MHz
UHF 520-820 MHz
MAX GAIN
VHF 26 dB
UHF 32 dB
VHF 15 dB
UHF 24 dB
VHF -2 dB
UHF 32 dB
NOISE
FIGURE
VHF < 3 dB
UHF < 2.5 dB
VHF < 3 dB
UHF < 2.5 dB
VHF < 3 dB
UHF < 2.5 dB
OUTPUT FIGURE
108 dB
DIN45004B
(-60 dB IMR)
108 dB
DIN45004B
(-60 dB IMR)
108 dB
DIN45004B
(-60 dB IMR)
45944-3_KM_series_IM.indd 6
20/08/14 3:38 PM