The specific description of the items displayed on this interface as follows:
(1) Pulse Speed: Display the pulse speed of feeding motor (factory setting:
12000 pcs/sec). Parameter adjustment will affect the cutting accuracy of
the equipment. Non-professionals should not modify it at will.
(2) Acceleration Time: Display the time of the feeding motor to reach the
set pulse speed (factory setting: 100Ms).
(3) Size Rectification: Display the cutting calculation multiple of the
device (factory setting: 490 magnification), which affects the cutting
accuracy. If there is a deviation, you can make fine adjustments in units of
1 magnification, and do not adjust them significantly.
(4) Delay Setting: It is used to set the cutting-interval time under
Automatic Mode ( Factory Setting: 3 seconds), and the user can modify it
according to actual demand.
(5) Language Setting: Chinese and English switching.
(6) Total Blade Operation: Display the cumulative use times of the blade.
Long press the function key for 3 seconds to clear the data.
(7) Total Cutting Length: Display the accumulated length of cutting length,
in meters. Long press the display area for 3 seconds to clear the data.
(8) Daily Cutting Length: Display the total length of cutting tape on the
day, in meters. Long press the function key for 3 seconds to reset the data.
(9) Device Information: Press this function key and enter the password
(6666) to enter the "Device Information" interface.
This part will introduce the specific operation of E-404 series water
activated paper tape dispensers.
1. First Step: Filling Water.
Remove the water bottle( black) and the side water tank (white) from
dispenser in turns. Fill water up to 4/5 of water bottle and fill water full of
water tank. Install water bottle and water tank back to the original position
to finished the filling process.
2. Second Step: Increase/Decrease Weight on Pressure Plate.
When chose reinforced water activated tape, the weight (fixed on the
press plate and needs to unscrew) on press plate needs to be installed into
the cylinder to ensure the tape wet evenly. When choose non-reinforced
water activated tape, do not need to install weights to avoid any blocks in
channel or unevenly wet on the tape.
3. Third Step: Install the Tape Roller.
Open the front and rear covers, pull the spring pressure roller and remove
the pressure plate. Place the water activated tape (Glue side should be up)
between the two rollers in the dispenser channel. Pull the tape (front-end)
backwards through the feed roller (glue side will be down) and make it
under the pressure roller. Put the press plate back to its original position to
complete the installation.
4. Fourth Step: Operation Mode and Operation Method.
In order to meet diversified sealing needs, this dispenser is equipped with two modes,
Automatic Mode and Manual Mode, and users can choose according to actual needs.
Manual Mode is suitable for application scenarios where multiple specifications are
frequently switched. The specific operation method: According to the actual cutting
length, Modify the cutting length corresponding to the 1-10 mechanical digital keys in
the "Manual Setting for Length" interface (factory setting value: 10, 20, 30...100) .
Press the "return" button to return to the "program setting" interface. Press the "start"
button, and then press the mechanical number keys to conduct the tape cutting
operation.
Part V Operating Instructions
www
.kingnodetech.com
09
10
Figure 5: Introduction Diagram for Placing the Tape Roller
