STEPS TO CLEAN DUST CUP
1. Take out the dust cup as shown in
Fig. 6.
2. Gently push the dust dump button to dump dust as shown in
Fig. 7, 8.
3. In case the suction power is insufficient when the waste has not reached MAX,
turn off the machine, repeat the above steps 1-2, detach dust cup cover and take
out the filter sponge for cleaning as shown in
Fig. 8, 9.
4. In case of cleaning the inside of the dust cup, please operate according to the
following steps
1)Rotate the dust cup cover to detach it and take out the filter sponge
(Fig. 9)
2) Take out secondary filter system
(Fig. 10)
;
3) Remove dust press panel and filter net
(Fig. 11)
;
4) Wash the separator under water tap and then dry it out;
5) Reassemble the dust cup and install it.
•Note:
After cleaning the filter components, dry them first before putting back into the
machine for use. It is suggested to expose to sunshine for 24 hours until they are
completely dry. Make sure each component is back in place otherwise it may cause
malfunction; do not allow water to get into the electrical components otherwise it may
cause malfunction.
WARNING
The plug must be removed from the power socket before any maintenance or
replacement.
If the power cord is damaged, replace them only by the factory or maintenance
center or similarly qualified persons.
