KING PHOENIX KPD1000, Руководство пользователя

Страница: 6 / 24

Page 6
BOTH DISH & DIRECTV:
1 . Route coax along TOP of arm to LNB .
2 . Fill coax connector with dielectric grease . Connect to
LEFT
LNB port .
Fill coax connector with dielectric grease to prevent corrosion.
Coax connection should be snug only. Do not over-tighten.
!
Left Side
KC1415
x x
Left Side
KC1415
x x
KC1422 KC1422
Fasten loom to arm
with cable ties
Leave enough slack in loom to prevent
binding when arm pivots up against dish
KC1423
Insert wires completely.
Crimp with pliers.
Fasten loom to arm
with cable ties
Leave enough slack in loom to prevent
binding when arm pivots up against dish
KC1423
Insert wires completely.
Crimp with pliers.
CONNECT LED LIGHTS (OPTIONAL)
2 . Splice wires from loom to LED wires, using the included Scotch-Lok connectors (black to black
and red to red) .
1. Cut off excess LED wire length.
3 . Route the loom down either side of the LNB arm and secure with provided cable ties . Bundle
any excess wire length to arm with cable ties .
4 . Tuck any excess loom back thru the dish . Leave enough loom out to prevent binding when
raising the LNB arm up against the dish .
5 . Lift LNB arm to make sure there is no stress on the loom as the arm is lifted up against dish .
The LEDs illuminate the dish at night, and are always on when there is power
to the controller. If you don’t wish to connect the LEDs, properly terminate and
secure the wires as they are “live” (12VDC present at all times).
!