ASSEMBLY
This drill press comes partially assembled and requires minimal assembly
and set up before being put into use.
INSTALLING TABLE HEIGHT ADJUSTMENT HANDLE
1. Align the set screw (A) Fig.6 in the table height adjustment handle (B)
with the flat portion of the handle shaft.
2. Slide the table height adjustment handle (B) onto the shaft and
tighten the set screw (A) using a 4mm hex. key.
RAISING THE HEAD
This drill press is shipped with the head lowered. To operate this drill
press correctly, the head must be raised.
1. Loosen the head locking handle (A) Fig.7 and place a block of wood
(B) on the table and under the bottom of the head as shown.
2. Loosen table lock handle (C), then turn table height adjustment handle
(D) to raise the head.
3. Once the head is positioned at a comfortable height, retighten head
locking handle (A) and table lock handle (C).
4. Loosen and move up the column collar (E) until it comes in contact
with the bottom of the head, secure the column collar up against the
head by tightening the large hex. bolt and hex. nut.
INSTALLING THE 5/8” CHUCk
1. Slide the 5/8” chuck (A) Fig.8 onto the tapered end of the spindle (B).
2. Place a piece of wood on the table and using the down-feed handles,
lower the quill assembly against the piece of wood on the table to
secure the chuck on the spindle.
FIGURE 6
ASSEMBLY
FIGURE 7
FIGURE 8
