KING Falcon KF1000, Инструкция по установке и эксплуатации

Страница: 26 / 36

Page 24
EXTERIOR
1. After establishing location of the antenna, drill a minimum 5/16” hole thru the roof where the
cable will enter the vehicle. Make sure to locate hole so it is not covered by the circuit board
when the antenna is set in place (Fig. 1).
2. Feed the long cable thru the hole (from inside or outside) leaving about two feet sticking out
of roof. Place all components and cables in position and make sure cables can reach all
components.
3. DO NOT TOUCH CIRCUIT BOARD AT ANY TIME! Feed long cable under the circuit board
as shown in the Fig. 2. Leave as large a bend as possible in the cable and push the cable
connector onto the circuit board connector until it clicks in place (hold the cable by the connector
and not the actual cable).
4. Fig. 3: Apply sealant around entire perimeter of base mount and fill coax port on rear of base
mount.
5. Feed cable down thru roof hole as you lower the base mount into position.
6. Fasten base mount to roof with appropriate fasteners. Seal (6) fastener heads.
INTERIOR (Go to page 28)
INSTALLATION OPTION 1: Concealed Cable
IMPORTANT! The installer is responsible for determining and supplying the most
appropriate fasteners to secure the base mount to the roof.
All holes, fastener heads, and the entire perimeter of the base mount
(including coax port) must be completely sealed and weatherproofed with
roof-compatible sealant.
IMPORTANT! The cables have different connectors on each end. Match the proper end of
cables to the components before routing.