READ ALL INSTRUCTIONS BEFORE USE
• Study, understand, and follow all instructions before operating this device.
• Failure to heed these markings may result in serious personal injury and / or property damage.
• Prior to each use, visual inspection shall be made to the device by checking for abnormal conditions,
such as cracked welds, leaks, and damaged, loose, or missing parts.
• Do not exceed the rated capacity stated.
• Use only on hard level surfaces.
• This item is to be used as a lifting device only. Immediately support the vehicle with appropriate rated
jack stands after lifting.
• Do not move the vehicle while it is on the jack.
• Lift only on areas of the vehicle as specified by
the vehicle manufacturer.
• No alterations shall be made to this product.
LIFTING
• Using the handle, turn the release valve clockwise to the closed position. Do not over tighten.
• Position the jack under the specified lift point.
• Begin lifting by pumping the handle up and down.
• Immediately after lifting, support the vehicle with appropriately rated jack stands.
• Turn the release valve slowly counterclockwise to lower the vehicle onto jack stands.
LOWERING
• Using the handle, turn the release valve clockwise to the closed position. Do not over tighten.
• Pump the handle up and down to lift vehicle off jack stands.
• Remove the jack stands. Do not get under or let anyone get under the vehicle while lowering.
• Turn the release valve slowly counterclockwise to lower the vehicle onto the ground.
CHECK AND REFILL OIL
• With the jack in the fully lowered, level position, if unit cover is provided, remove unit cover, then remove
oil filler plug.
• Proper oil level should be just covering inner cylinder as seen from the oil filler plug hole.
• Do not overfill. Always fill with new, clean hydraulic jack oil as recommended above.
• Reinstall oil filler plug, then reinstall unit cover.
LUBRICATION AND CLEANING
• Periodically clean and lubricate all moving parts and pivot points.
9TYT138-03A-B
3
192(7-1/2
")
533(21
")
KT NO.
Capacity (T)
Min height (mm)
Max height (mm)
