Remark :
1. Setting amperage too high or time too long can cause workpiece surface damage.
2. Setting correct amperage and time according to the workpiece thickness.
3. Continuing another operation is applicable after these procedures finished.
If not, please shut the power off and switch off the unit.
4. Triangle washer welding can replace washer welding. It can draw out the concavity
directly after welded.
c. Triangle Washer Welding
Set correct time.
Connect negative outside
wire to a clean paint free
location on metal workpiece
as close to welding area
as possible.
Connect triangel washer
pull hammer with welding gun.
Select welding function.
Slide the hammer to opposite
directionto pull the dent.
Approximately a 90° angle to the
dent. Put on pressure and
press trigger.
(Position A is recommend)
Set correct power
11