8
Water
CYCLER
MeteredPoolPurifier
400 SERIES
Water
CYCLER
MeteredPoolPurifier
AUTOMATIC
WATER
TREATMENT
SYSTEM
TOOLS NEEDED
Pipe Wrench
Hacksaw
Tape Measure
MATERIALS NEEDED
Pipe Thread
Sealant
Primer and
PVC Cement
Two 2” Threaded
x 2” or 1 1/2” Slip
Male Adapters
(not Included)
RECOMMENDED
1.
2.
Hard-Plumbed Installation
OR
Do NOT install in copper pipe as chemical
corrosion may lead to pipe failure.
Do NOT install an in-line
Sparco System off-line.
Bi-flow valve design allows
installation in either flow direction.
Following pipe thread sealant
directions, brush sealant onto
Sparco System threads in both
ports and both male adapters.
DO NOT USE
PIPE THREAD TAPE
Screw a male adapter
into each port of the Sparco
System. Hand tighten. Finish
tightening by turning 1 to 2
revolutions with
a pipe wrench.
DO NOT OVER
TIGHTEN.
Insert PVC pipe into male
adapters with a twisting
action. Hold in place
5 to 10 seconds to bond.
To prevent damage to
heaters or filters, see your
dealer about installing a
corrosion resistant check
valve
which will reduce the
back flow of chlorine gas
when the Sparco System is
turned off.
3.
4.
5.
6.
Primer
Measure the distance
between the Sparco System
male adapters and cut out a
section of pipe 3” less than
that dimension.
Following Primer directions,
brush Primer on the inside of the
male adapters and to ends of
pipe. Repeat this process with PVC
cement following manufacturer’s
directions on that product.
Allow a minimum
of 12” above
and on each side
of the Sparco
System to ensure
room for easy
replacement of
Sparco Chamber.
AUTOMATIC
WATER
TREATMENT
SYSTEM
AUTOMATIC
WATER
TREATMENT
SYSTEM
AUTOMATIC
WATER
TREATMENT
SYSTEM
12"
to
15"
12"
to 15"
12"
to 15"
Water
CYCLER
MeteredPoolPurifier
AUTOMATIC
WATER
TREATMENT
SYSTEM
The Sparco System should always be installed between
the filter and pool (or between heater and pool if
applicable).
Never install Sparco SYSTEM before the
heater or damage to the heater could occur.
Primer
PVC
Cement
For better stability, Sparco
System may be mounted on
a treated wood base using
Phillips pan head screws,
one in front and one in back.
If you have questions about
stability, please contact your
dealer or King Technology.
4-8 psi Back Pressure
To avoid over or under chlorination,
replace eyeball fittings in the
return jets to a smaller or larger
size to adjust back pressure. For
best results use King Technology’s
pressure
gauge, order
part number
01-22-4000.
PVC
Cement
