Page
57 of 76
King Pigeon Communication Co., Ltd.
V1.0
www.iot-solution.com
Modbus to MQTT IoT Gateway
-BL101
enter datapoint configuration box, repeat Step (2)-(11)
Note: Click Save Data. Gateway will restart automatically. After restarting, M140T
datapoints are added successfully
5.2.1.4 LAN Port Configuration
Note: Both WAN and LAN can collecting data from devices. Below example is the
configuration of adding device S475 in LAN port. WAN port device configuration
procedures are the same.
(1) Double click LAN to enter configuration box
(2) DHCP: enable auto IP distribution. Default is disabled. For examples, S475 has
been set to auto retrieving IP, then LAN port must enable DHCP.
(3) Routing: Enable network rounting function. Default is disabled. For example, S475
data will be collected without network requirement, then disable routing function
(4) IP Address: defaut is 192.168.3.1, the IP addresses assigned to LAN port devices
must be within the range. It can be changed according to requirement. For
example, S475 is set to auto retrieving IP and the range is not limited,thus it’s not
necessary to change it.
(5) MAC Addres: Input LAN port MAC address
(6) Click OK to confirm it
Note: Click Save Data and Gateway will restart. Turn off the power of Gateway and
restart it. After that LAN port configuration is done successfully
Note: LAN Port IP Address specifies the IP address arrange of LAN port device. If
device IP address is not within the range, data can’t be collected. Thus it’s necessary