AUS OA8300 08-03-17
1. Turn on TV.
2. Turn on power to KING Jack antenna.
3. Perform a channel scan per the digital TV or digital TV
converter box manufacturer’s instructions.
4. Rotate antenna 90 degrees. Scan again.
5. Rotate antenna 90 degrees. Scan again.
6. Rotate antenna 90 degrees. Scan again.
7. Reposition your KING antenna to where you received the most channels.
Choose one of those channels on your TV. Now monitor the signal strength
screen and fi ne tune the KING Jack until the highest signal strength is achieved.
Perform one fi
nal scan and watch TV. Enjoy!
The optional KING SureLock Digital TV Signal Finder allows you to pinpoint the location
of local DTV towers and eliminate the need for multiple channel scans. It also allows
you to more accurately locate distant towers that might be missed with the 4 quadrant
scan. Consult your local dealer or visit www.kingconnect.com for more information.
IMPORTANT! Do not power wash any part of the KING Jack antenna.
OPERATING INSTRUCTIONS: Scanning for Channels
TROUBLESHOOTING
SYMPTOM
POSSIBLE REASON
COURSE OF ACTION
No TV reception.
No power to antenna.
(Red LED on antenna head
is not lit.)
Antenna pointed in wrong
direction.
Make sure power supply is plugged into a known good power source.
Check for 12 VDC at power supply output. If not present, replace power supply.
Check for 12 VDC at antenna port of power injector. If voltage is not present, replace power
injector.
If voltage is present, the coax to the antenna or the antenna is bad.
Temporarily run a known good coax from the injector to the antenna. If you now have power
(red LED lit), replace the coax. If you don’t, replace the antenna.
Perform a 4 quadrant search as shown in the operating instructions or use a
KING SureLock Signal Meter to locate TV towers.
KING SureLock™
Digital TV Signal Finder
SL1000
(sold separately)
NOTE:
In stationary applications, you only need to scan for channels one time. In mobile applications, you will need to scan for
channels each time you change locations.
NOTE:
In steps 3-6, keep track of the position
where you receive the most channels.
Part #040286
LIMITED WARRANTY
Every new KING Jack HDTV Antenna is covered by the following one-year parts limited warranty from the date of original purchase:
• One-year parts warranty: The customer is not responsible for the cost of replacement parts if the original part is determined to be defective under the terms of the warranty. The customer is
responsible for the cost of replacement parts after one year.
Should any trouble develop during the warranty period, contact the Australian/New Zealand distributor, Camec, before the warranty period expires. If a fault covered by the Warranty occurs, the Purchaser
must fi rst contact Camec. Contact with Camec may be made in any of the following ways:
• Australia:
(a) Phone 1300 654 936, (b) Fax 03 9799 4476, (c) Email: [email protected]
• New Zealand: (a) Phone 64 9 257 2419, (b) Fax 64 9 255 1910
Any Warranty claim from the Purchaser must be accompanied by: (a) Proof of purchase, (b) Return of the product, and (c) Full details of the alleged defect.
The cost of delivery and insurance of the Product to and from Camec and the cost of testing the Products are the responsibility of the Purchaser.
This Warranty does not cover installation and external wiring, or remanufactured units. This Warranty is not transferable from the original owner. This warranty also does not apply where:
• The product has been abused, misused, improperly installed or improperly maintained.
• Repairs have been made or attempted by others that are not certifi ed by Camec to do such repairs.
• Repairs are required because of normal wear and tear.
• Alterations have been made to the product.
• The product enclosure has been opened.
• Damage has been caused by power washing.
• Supplied grease not used in the external coax connection as specifi ed in the instructions.
• Circumstances beyond the control of Camec cause the product to no longer operate correctly.
• Customer is not the original owner.
In no event shall Camec be liable for any indirect, incidental, or consequential damages from the sale or use of the product. This disclaimer applies both during and after the term of the warranty. Camec
disclaims liability for any implied warranties, including implied warranties of “merchantability” and “fi tness for a specifi c purpose,” after the one year term of this warranty.
Camec Pty Ltd - 47-63 Remington Drive, Dandenong South Victoria, Australia www.camec.com.au • Camec NZ Ltd - 44 Montgomerie Road, Mangere Auckland, New Zealand www.camec.co.nz
Page 4
Winegard is a registered trademark of Winegard
®
Company. KING Jack
™
and KING SureLock
™
are products of KING
®
and are not affi liated with nor manufactured by Winegard
®
Company.
© 2017 KING 22680 REV A
KING Jack and KING SureLock are trademarks, and KING is a registered trademark of Electronic Controlled Systems, Inc.
More information https://www.caravansplus.com.au