(Multiply the indicated flow by the value of
"
X
" to obtain the actual flow at the corrected
pressure.)
X =
14.7 + operating pressure
14.7
METERS FOR GAS SERVICE
Meters used in gas service may be susceptible to float bounce. (This is espcially true in
low density gas applications.) To reduce the possibility of float bounce, valves should be
installed at both ends of the meter. Make sure there is minimum piping between the valve
and the meter body.
During start up (with both valves closed) open the inlet 1/2 turn, then slowly open the
outlet two turns. Return to the inlet and open another two turns. Now adjust a combination
of the valves to achieve desired flow. Make sure to open the valves slowly. If the float
begins to bounce, close the valves immediately and begin procedure again.
Both the inlet and outlet valves should be opened to the minimum required to achieve the
desired flow. Follow this procedure during each start up.
A pressure gage installed between the outlet of the meter and the downstream piping will
show the pressure in the meter and will allow the exact flow to be calculated by deriving
a mulitiplier (
X
) using the formula shown below.
FLOWMETER LIMITED WARRANTY
Meters are warranted against defects in materials and workmanship to the original user for a period of thirteen (13) months from
the date of factory shipment, provided the meter is installed, operated and maintained in accordance with the Company's instructions
and recommendations.
This warranty does not apply if the failure is caused or contributed to by any of the following: improper handling, improper storage,
improper installation, abuse, unsuitable application of the product, lack of reasonable and necessary maintenance, use exceeding
suggested pressure and temperature maximums, improper packaging for return, or repairs made or attempted to be made by
other than the Company.
THE COMPANY MAKES NO WARRANTY AS TO THE FITNESS OF ITS PRODUCTS FOR SPECIFIC APPLICATIONS.
This warranty is valid for the original end-user only and does not apply to products that have been damaged or modified. This
warranty is nontransferable and is limited to replacement or repair. The liability of the Company arising out of its supply of the
products, or their use, shall not in any case exceed the cost of correcting defects in the products as above set forth.
THIS WARRANTY IS A LIMITED WARRANTY AND SHALL BE IN LIEU OF ANY OTHER WARRANTIES, EXPRESS OR IMPLIED,
INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OR MERCHANTABILITY OR FITNESS FOR A PARTICULAR
PURPOSE. THERE ARE NO OTHER WARRANTIES WHICH EXIST BEYOND THE DESCRIPTION OR FACE HEREOF.
IN NO EVENT SHALL THE COMPANY BE LIABLE FOR LOSS OF PROFITS, INDIRECT, CONSEQUENTIAL OR INCIDENTAL
DAMAGES.
Products should be returned, prepaid, to the Company with proof of purchase.
KING INSTRUMENT COMPANY
12700 Pala Drive, Garden Grove, CA 92841
Phone (714) 891-0008 Fax (714) 891-0023
Содержание 7459
Страница 4: ......
