ASSEmbLY, uSAGE & mAinTEnAncE
ASSEmbLY
installing top handle
1. Install the top handle (A) Fig.1 onto the shaft on the top of the canister filter,
align the hex. bolt (B) with the flat of the shaft, slide handle onto shaft and
tighten hex. bolt to secure top handle.
installing sealing foams
1. Install the larger foam (A) Fig.2 around the top edge of the dust collector
housing (B) as shown. Remove bottom dust bag and install the smaller foam
(C) around the bottom edge of the dust collector housing, reinstall bottom dust
bag.
installing canister filter on dust collector housing
1. Install the canister filter (A) Fig.3 over the top edge of the dust collector
housing (B) as shown. Make sure the canister filter is pushed down all the way.
2. Secure the canister filter to the dust collector housing using the supplied
retaining strap (C).
uSAGE/mAinTEnAncE
After considerable use, there will be dust build-up in the filter which will reduce
long term efficiency. The top handle (A) Fig.1 is used to dislodge dust build-up in
the filter. Turning the top handle rotates rubber flaps which disloge dust and
increase long term efficiency. Periodically clean the filter with compressed air.
FiGurE 1
FiGurE 2
FiGurE 3
