CHANGING BLADES
Removing blades
Warning!
Unplug the saw from the power source
before attempting to remove blades.
1. Press and hold the spindle lock button (A)
Fig.3 to lock the blade spindle.
2. Undo the arbor nut (A) Fig.4 using the
supplied adjustment tool (B). Turn adjustment
tool in a counterclockwise direction.
3. Remove the arbor bolt (A) Fig.5 and the arbor
flange (B) and open the lower blade guard.
4. Lift and remove the top “B” blade (C) and then
lift and remove the bottom “A” blade (D).
Installing blades
Warning!
Unplug the saw from the power source
before attempting to install blades.
1. Open the lower blade guard.
2. Position the bottom “A” blade (D) Fig.5 onto
the outer blade spindle, turn the blade until its
cutouts fit perfectly into the backing plate.
3. Position the top “B” blade (C) Fig.5 onto the
inner blade spindle, turn the blade until its
cutouts fit perfectly into the backing plate.
4. Position the arbor flange (B) Fig.5 over the top
“B” blade and hand tighten the arbor bolt (A).
5. Press and hold the spindle lock button (A)
Fig.3 to lock the blade spindle.
6. Using the supplied adjustment tool, turn arbor
bolt in a clockwise direction to secure the
blades.
Optional accessories
A variety of optional accessories are available for
your Double Cut Saw. Listed below are the
available King Canada accessories;
• 6-3/8” TCT Universal blade set (KW-9161)
• 6-3/8” Diamond stone blade set (KW-9162)
• Pivoting base & edge guide (KW-9166)
• Laser attachment (KW-9111)
• 25pc. lubricating wax sticks (KW-9112)
Contact your local King Canada distributor for more information on these accessories.
FIGURE 3
FIGURE 4
FIGURE 5
MAINTENANCE
INSPECTING/REPLACING CARBON BRUSHES
Warning! Only use identical replacement carbon
brushes, both carbon brushes should be
replaced at the same time, normally after 50
hours of operation.
Unscrew and remove the carbon brush covers
(A) Fig. 6 (one on each side) which secure the
carbon brushes (B) inside the tool. Take out the
carbon brushes and inspect them. If the wear of
the carbon brushes has gone past the side limit
mark, install new brushes. Reinstall all parts in
reverse order.
FREQUENT INSPECTION AND MAINTENANCE
The tool should be inspected and maintained frequently. Check and make sure the power
cord, internal wires, plug and switch are in good condition. Make sure the insulation
resistance is within normal limits, contact between the brushes and the commutator are
good, and that there is no short-circuit or breakage of the armature and stator windings.
Check the blades, bearings and driving parts also.
Do not allow brake fluid, gasoline, petroleum-based products such as penetrating oils to
come in contact with plastic parts. They contain chemicals which can damage, weaken or
destroy the motor housing, thus compromising the intergrity of the double insulation.
Inspect mounting screws regularly, making sure they are properly tightened. Tighten all
loose screws before operating.
It is a known fact that electric tools are subject to accelerated wear and possible
premature failure when they are used to work on fibre glass and drywall or plaster. The
chips and grindings from these materials are highly abrasive to electrical parts, such as
bearings, brushes and commutators. Consequently clean the tool even more intensely
after working these materials.
Due to the double insulation of this tool, the service should only be done by a qualified
service technician using identical replacement parts.
PARTS DIAGRAM & PARTS LISTS
Refer to the Parts section of the King Canada web site for the most updated parts diagram
and parts list.
FIGURE 6
