MAINTENANCE
MAINTENANCE
IMPORTANT
: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustments should be performed by an authorized service center or other qualified
service technician, always using identical replacement parts.
1. Air vents of the tool should be cleaned regularly to avoid overheating of the motor which
is caused by the blocking of the air vents.
2. DON’T clean this tool with water, as no liquid is allowed in the tool body. Clean the tool
with a dry clean cloth only. Compressed air at low pressure is also suitable.
3. DON’T allow petroleum based products to come into contact with the plastic parts of
the tool, as they contain chemicals that can damage or destroy the plastic parts.
CARBON BRUSHES
Remove and check the carbon brushes regularly (normally after 50 hours of use). The
carbon brushes are installed inside the motor housing. Using a screwdriver, remove the
4 pan head screws that hold the motor housing cap in place.
Remove the carbon brush from the motor housing and inspect it. Repeat this step for the
second carbon brush. Carbon brushes need to be replaced once they wear down to the
small limit mark. Keep the carbon brushes clean and free to slip in the holders.
If they have worn down to the limit mark, purchase a set of identical replacement carbon
brushes (both carbon brushes should be replaced at the same time). Install new carbon
brushes and reinstall the motor housing cap using the 4 pan head screws.
If you are unsure about these instructions, we recommend that you get a qualified service
technician to replace the carbon brushes. Contact a King Canada service centre.
PARTS DIAGRAM & PARTS LISTS
Refer to the Parts section of the King Canada web site for the most updated parts diagram
and parts list.
