ASSEMbLY
UNPACKINg
Open and remove loose contents from the box, carefully remove Wet/Dry
Sharpener by the base or by the top mounted carry handle. Never transport the
Wet/Dry Sharpener by its wheels or its accessories. Place the Wet/Dry
Sharpener on a stable, flat work surface.
INSTALLINg THE gRINDINg/SHARPENINg WHEEL
This Wet/Dry Sharpener comes with a 10” 220 grit grinding/sharpening wheel,
and needs to be installed as follows:
1. Remove the large nylon hex. nut (A) Fig.4 using a 19mm wrench (counter-
clockwise) and then remove the outer flange washer (B) from the spindle.
2. Install the grinding/sharpening wheel (C) Fig.4 onto the spindle, making sure
the wheel gets pushed completely up against the inner flange washer (D).
3. Slide the outer flange washer (B) Fig.4 onto the spindle, then install large nylon
hex. nut (A) (clockwise). Do not overtighten, risk of cracking grinding/
sharpening wheel.
4. Rotate the wheel by hand several turns, verify and make sure the wheel is
balanced and rotates smoothly.
INSTALLINg THE WATER TRAY
This Wet/Dry Sharpener comes with a water tray (A) Fig.5 which can be installed
in two different heights on the left side of the machine base. When installing a
new 10” grinding/sharpening wheel, the water tray gets installed in the two lower
mounting holes (E) Fig.4. As the grinding/sharpening wheel wears down to
approx 8” in diameter, you will need to adjust the water tray height by installing it
in the two upper mounting holes (F) Fig.4.
1. Slide the water tray (A) Fig.5 behind the 10” grinding/sharpening wheel (B).
2. Attached the water tray notches into the two lower mounting holes (E) Fig.4.
3. Refer to the "Filling The Water Tray" instructions in the Adjustments section of
this manual.
INSTALLINg THE UNIVERSAL SUPPORT
The universal support (A) Fig.6 is used as a work rest and as a jig attachment
support. The universal support can be installed either in the front (left-
grinding/sharpening) vertical position (Fig.6 shows vertical-left position) or in the
rear (left-grinding/sharpening or right-honing/polishing) horizontal position.
1. Select the orientation of the universal support (A) Fig.6 (vertical or horizontal).
Orient the universal support so that it extends over the wheel you’ll be working
with.
2. For vertical orientation (grinding/sharpening only), loosen the two lock knobs
(B) Fig.6 and slide the universal support (A) into the mounting holes.
CAUTION!
For honing/polishing operations, the universal support must be
installed in the horizontal position only.
3. For horizontal orientation (grinding/sharpening & honing/polishing), loosen the
two lock knobs (B) Fig.7 and slide the universal support (A) into the mounting
holes.
4. Adjust the height/position of the universal support, this must be done to suit
your tool to sharpen/polish. Make sure the universal support is parallel with the
surface of the wheel being used (vertical or horizontal position).
5. Once the universal support height/position is set, tighten the two lock knobs
(B) Fig.6 or (B) Fig.7.
FIgURE 4
FIgURE 5
FIgURE 6
FIgURE 7
