ASSEMBLY
1. Install the four casters (A) Fig.5 to the under side of the base (B). Do
not remove the lock washers and nuts from caster roller shafts; these
act as spacers. Insert caster shaft into threaded hole on the underside
of the base, turn until it is snug, then tighten nut with wrench.
2. Place base with casters (A) Fig.6 on the ground and attach the motor
and fan housing assembly (B) to the base using 4 hex. bolts and 4 flat
washers.
3. Attach inlet cover (A) Fig.7 to fan housing (B) using 8 pan hd screws.
4. Attach the three support brackets (A) Fig.8 to the base (B) using 6
hex. bolts and 6 flat washers. Hand tighten only at this point.
5. Attach hose adapter (C) to inlet cover (D) by pressing it into the inlet
cover opening.
FIGURE 5
FIGURE 6
FIGURE 7
FIGURE 8
