ASSEMBLY
INSTALLING FRONT RAIL AND TUBE ASSEMBLY
Place and align the mounting holes of the front rail and tube
assembly (A) Fig.8 with the holes in the front lip of the table (C)
and extension wings (D & E). Install the front rail and tube
assembly to the table and extension wings using 4 hex. bolts, 8
washers, 4 spring washers and 4 hex. nuts. Before securing it in
place, adjust it up or down to ensure the front rail edge is set at
3/16” below the beveled edge of the table and extension wings.
Once adjusted, tighten all 4 bolts.
INSTALLING REAR RAIL
Place and align the mounting holes of the rear rail (B) Fig.8 with
the holes in the rear lip of the table (C) and extension wings (D &
E). Install the rear rail to the table using 2 hex. bolts and 2
washers. Then 2 use hex. bolts, 4 washers, 2 spring washers and
2 hex. nuts to fix the rear rail to the extension wings. Before
securing it in place, adjust it up or down to ensure the rear rail
edge is set flush with the lowest edge of the miter gauge slot (to
allow free movement of the miter gauge). Once adjusted, tighten
all 4 bolts.
INSTALLING LAMINATED EXTENSION TABLE
Once both rails are installed, place the laminated extension table (F) Fig.8 between
the front and rear rails. Fix it in place using hex. bolts, washers, spring washers and
hex. nuts. Before securing it in place, adjust it up or down to ensure the top of the
laminated extension table is set flush with the top of the right side extension wing
(E). Once adjusted, tighten all bolts.
INSTALLING MEASURING TAPE
Only proceed with this step once the rip fence system has been adjusted and that
the fence is perfectly parallel with the saw blade. See “Fence Adjustments”. Slide
the fence against the saw blade. Place the measuring tape on the tube (A) Fig.8
under the pointer window (A) Fig.9. The pointer window contains 2 small red lines
which represent the thickness of the blade kerf, line up the zero mark of the
measuring tape underneath the red line on the left side. Make sure the measuring
tape is positioned perfectly parallel to the tube and that the measurements are
clearly visible. Remove the fence. Peel away a small portion at a time of the
measuring tape backing and carefully install. We suggest taking your time during
this installation, if a mistake is made and the zero mark does not align perfectly,
loosen the pointer window screws (B), reposition the pointer window in the correct
position and retighten the screws.
INSTALLING SUPPORT LEGS FOR LAMINATED EXTENSION TABLE
(KC-26FXT/I50/5052 ONLY)
Fasten the 2 support legs to the inner edge of the laminated extension table using
4 hex. bolts, 8 washers, 4 spring washers and 4 hex. nuts. Refer to the parts
diagram for assembly.
Once installed, the adjustment feet must be adjusted properly to offer adequate
support. Turn the adjustment feet until they both bottom out against the floor and
tighten the upper hex. nut against each support leg to secure them in place.
INSTALLING MAGNETIC SWITCH TO FRONT RAIL
The magnetic safety switch (A) Fig.10 comes attached to a mounting bracket (B),
mount the mounting bracket to the underneath the left end of the front rail (C) using
2 hex. bolts and washers.
FIGURE 8
FIGURE 9
FIGURE 10
