ASSEMBLY
WARNINg
: To avoid injury, if any parts are missing, do not attempt to assemble
the bandsaw, plug in the power cord, or turn the switch on, until the missing parts
are obtained and installed correctly.
WARNINg
: For your own safety, never connect plug to power source outlet, or
insert switch key until all assembly steps are complete and until you have read
and understood the entire instruction manual.
MOUNTINg STAND TO BANDSAW BASE
1) Place bandsaw on its side on a small workbench with the base clear of the
workbench in order to assemble stand legs.
2) Secure 4 legs (A) Fig.4 to the underside of the bandsaw base (F) using 8
carriage bolts, washers and hex. nuts (D).
3) Fix long and short braces (B & C) Fig.4 to the legs using 8 carriage bolts,
washers and hex. nuts (D). At this point do not fully tighten the hex. nuts.
4) Install 4 rubber feet (E) Fig.4 onto legs (A).
5) Place bandsaw upright on a level floor, tighten all hex. nuts.
INSTALLINg THE TABLE
1) Position the table (A) Fig.5 to allow the blade to slide into the table slot. Slide
the blade through the slot in the table and then place the table onto the
bandsaw trunnion (B).
2) Align the four mounting holes of the table with the ones in the trunnion.
3) Fasten the table to the trunnion using four cap screws and washers (C) Fig.5.
INSTALLINg RIP FENCE RAIL AND RIP FENCE
1) Install guide rail (A) Fig.6 to the front of table. Slide rail slots over the 4 lock
knob shafts found under the table. Loosely secure the guide rail using the four
lock knobs (B) under the table.
2) Slide rip fence assembly (A) Fig.7 onto the table. The fence body should
engage the guide rail (B).
3) Lock the fence by lowering the lock handle (C) Fig.7.
If the rip fence is not parallel to the miter slot:
1) Slide fence next to miter slot and lock rip fence, verify for alignment. If an
adjustment is needed, loosen two cap screws (D) Fig.7 using a hex. key.
2) Adjust fence body so it is parallel to the miter slot.
3) Retighten two cap screws (D).
FIgURE 4
FIgURE 5
FIgURE 6
FIgURE 7