ASSEMBLY & ADJUSTMENTS
INSTALLING AND USING THE LIMIT SWITCH PROTECTED
SAFETY GUARD continued...
2) Remove cap screw (A) Fig.15 from the bar and safety guard assembly
(B).
3) Slide the bar and safety guard assembly (B) up into the limit switch
bracket (C). Reinstall cap screw (A).
4) Adjust the height of the bar and safety guard assembly and secure its
position by tightening lock knob (D).
It is recommended to test the limit switch safety guard before any drilling
operation. Turn drill press on and open the safety guard, the drill press
MUST shut off. If it doesn’t, the safety guard needs to be reinstalled
correctly.
INSTALLING THE CHUCK
1) Locate the 3/4” chuck (A) Fig.16 and arbor (B) in the box of parts.
2) Clean out the tapered hole in the chuck, also clean the arbor nose with
a clean cloth. Make sure there are no foreign particles sticking to the
surfaces. The slightest piece of dirt on the arbor nose or the chuck will
prevent the chuck from seating properly. This will cause the drill to
“wobble”.
NOTE:
If the tapered hole in the chuck is extremely dirty, use a cleaning
solvent on a clean cloth.
3) Push the chuck up on the arbor nose and arbor nose up into the drill
spindle (C) as far as they will go.
4) Turn the chuck sleeve clockwise and open the chuck jaws com-
pletely.
5) Lightly tap the nose of the chuck with a piece of wood to insure the
proper seating of the chuck on the arbor.
REMOVING THE CHUCK & ARbOR
1) Lower the quill using using the feed handles. Align key holes in spindle
and quill (A) Fig.17 as shown by rotating the chuck (C) by hand.
2) Insert drift key (B) into key holes in the quill.
3) Tap key drift key lightly until the chuck and arbor fall out of the spindle.
NOTE:
Place one hand below the chuck to catch it when it falls out.
FIGURE 15
FIGURE 16
FIGURE 17
