ELECTRICAL REQUIREMENTS
MODEL: KC-10FX
POWER SUPPLY
WARNING:
YOURTABLE SAW MUST BE CONNECTED TO A
20-AMP, BRANCH CIRCUIT AND USE A 20-AMP TIME DELAY
FUSE OR CIRCUIT BREAKER. FAILURE TO CONNECT IN THIS
WAY CAN RESULT IN INJURY FROM SHOCK OR FIRE.
Your table saw must be properly grounded. Not all outlets are
properly grounded. If you are not sure if your outlet is properly
grounded, have it checked by a qualified electrician.
WARNING:
IF NOT PROPERLY GROUNDED, THIS JOINTER
CAN CAUSE ELECTRICAL SHOCK, PARTICULARLY WHEN
USED IN DAMP LOCATIONS. TO AVOID SHOCK OR FIRE, IF
THE POWER CORD IS WORN OR DAMAGED IN ANY WAY,
HAVE IT REPLACED IMMEDIATELY.
GROUNDING
This table saw must be grounded. If it should malfunction or
breakdown, grounding provides a path of least resistance for electric
current, to reduce the risk of electric shock. This table saw is
equipped with a cord which will require a 220V equipment-
grounding conductor and grounding plug. The plug must be
plugged into an appropriate outlet that is properly installed and
grounded in accordance with all local codes and ordinances.
WARNING:
TO MAINTAIN PROPER GROUNDING OF YOUR
TABLE SAW, DO NOT REMOVE OR ALTER THE GROUNDING
PRONG IN ANY MANNER.
There is no plug supplied with the motor, therefore to operate at 220V,
a plug with two flat, current-carrying prongs in tandem, and one
round or “U” shaped longer ground prong, as shown in Fig. 1, must
be installed. This plug is used only with proper mating 3-conductor
grounded receptacle, as shown in Fig. 1.
WARNING!
ALL ELECTRICAL CONNECTIONS MUST BE DONE BY A QUALIFIED ELECTRICIAN. FAILURE TO COMPLY MAY RESULT IN
SERIOUS INJURY! ALL ADJUSTMENTS OR REPAIRS MUST BE DONE WITH THE TABLE SAW DISCONNECTED FROM THE
POWER SOURCE. FAILURE TO COMPLY MAY RESULT IN SERIOUS INJURY!
FIGURE 1
PROPERLY GROUNDED OUTLET
CURRENT
CARRYING PRONGS
GROUNDING PRONG
