King Controls King Dome 9760 Series, Руководство по устранению неисправностей

Страница: 12 / 60

Page 10
SECTION 5
AUTOMATIC SATELLITE SWITCHING
DIRECTV
To receive programming from the DIRECTV 101 satellite only, your receiver must be set for
round dish-1 satellite (do this through the receiver’s satellite set-up menu screens).
To automatically switch between the 101 and 119 satellites for DIRECTV, choose the DTV
101/119 option (see
SET SATELLITE SERVICE ), and make sure your receiver is set for
oval dish-2 satellites (do this through the receiver’s satellite set-up menu screens).
For DIRECTV HD programming the Trac-King allows you to receive the specially formatted HD
signals from DIRECTV’s 110° satellite and automatically switch between satellites 101/110 and
101/119 when simply changing channels.
With a properly installed HD converter accessory
#9747 or #9747-AM, the King-Dome will receive available HDTV programming from
DIRECTV Ku band satellites at 101°, 110° and 119°. It will not receive channels broadcast
from DIRECTV’s Ka band satellites at 99° and 103°.
(See Section 6, DIRECTV HDTV.)
The automatic satellite switching feature can be active on 1 or more receivers depending on how
the system is installed. The two options for automatic satellite switching are as follows:
Automatic Switching from any receiver
To automatically switch satellites from any receiver location when the installation includes 2 or
more satellite receivers, the #1810 multi-switch must be installed in-line (see pages 19 and 21).
This allows any of the receivers to provide the switching command to the antenna when a
channel from the alternate satellite is selected, provided that all other receivers are tuned to a
channel on an odd transponder on the 101 satellite such as channel 202. (At the time of
publication, channel 202 is broadcast on an odd transponder on satellite 101. This is subject to
change. If in doubt whether channel 202 is still on an odd transponder, contact DIRECTV or call
King Controls.)
Automatic switching for select receivers only
To selectively enable or disable automatic satellite switching when using multiple receivers, one
or more tone block accessories (#1832) may be required. Please contact King Controls for
configuration options.
Manual Switching
To disable automatic switching, manually select your desired satellite using the controller as
outlined in
SET SATELLITE SERVICE .
Note: Unit must have software revision 5.22c or higher. See Section 9, Diagnostic Pages, to determine software
revision of unit.