WALLS AND LEGS ASSEMBLY
Step 1
Unfold each of the walls.
• The back wall (solid) and front wall (with zippers)
• The 2 side walls
Step 2
to be placed on the top pipe of your canopy structure by wrapping the fastening strips over the perimeter
poles. Repeat with second side wall, rear wall and front wall.
NOW, CONNECT THE LEG POLES TO THE ROOF ASSEMBLY WITH THE COVER ALREADY POSITIONED ON
TOP OF THE UNIT.
Step A: First insert the pipes for the middle poles into the 3- and 4-way
connectors, and then connect the end leg pipes in the same way.
(See illustration)
Step B: Push the eight foot pads onto the bottom of each leg.
NOTE: the foot pads are NOT for anchoring the canopy!
Step C: Connect the hook & loop fastening strips down
the length of each leg.
Step 3
After connecting the top of the side walls and installing the leg pipes into the connectors on the perimeter
of the unit, use curtain clips to connect the end of each sidewall to the 4 corners of the unit.
Slip one clip onto each of the corner legs.
To secure the clips on the corner legs use the drawstring sewn into each end
of the cover. Adjust the drawstring evenly on each side of the canopy by
pulling the drawstrings on each end of the cover at the same time. Insert the
ball on the drawstring into the slot on the curtain clip. Pull the clip down until
tight. Pressure from the drawstring will cause the clip to wedge onto the pipe.
Curtain clips may have to be re-tightened occaisonally due to strong wind gusts.
IMPORTANT! Once the legs and cover are assembled, your canopy will act like a kite in the wind. It is
imperative that the canopy anchors be installed NOW!
Start at Peak
Attach Left to Right
Insert Second
Insert First
Inside View of Hook
and Loop Fasteners