FRAME & COVER ASSEMBLY
1. Place all 3WLC’s and pipe on the ground as shown if figure 1. There is 1 swedged end pipe that is used
with the center pipe to form the length.
2. Start by connecting the center 60” pipe to the 52” swedge pipe. Then assemble each side to complete
the framework as shown in figure 2.
3. Place tarp over the frame. Tie elastic ball straps as shown in figure 3. When tying the elastic ball straps,
alternate from one side to the other for easier installation. (2 sides of the tarp will not have ball straps.)
4. Place the framework over the kennel. Attach the frame to the kennel by using the single sided clamps.
5. Once the framework is attached, use the remaining ball straps to attach the cover to the frame of the
kennel.
Begin attaching the cover with the elastic ball straps by inserting the elastic cord of the ball strap underneath
the cover and through the grommet. Then pull cord taut until ball stops. Wrap the cord around the pole and
under the ball. This will hide the ball under the cover and provide a more finished look to your unit.
• Start by attaching 2 elastic ball straps at each of the four corners
• Continue attaching straps from left to right in a zigzag pattern down both sides of the canopy
• Attach straps at the front and back of the unit, again using a zigzag pattern until all straps are secured
Note:
The ball straps are long enough to accommodate various cover lengths. If your straps need a tighter fit, they
can be shortened by making an additional knot in the cord strap. Slide the ball upward to reveal the tied knot.
Tie a new knot above the old one. The size of the knot will determine how short the strap becomes. Slip the
ball down over the new knot and secure.
Figure 1
Figure 2
Figure 3
