Step 21) The windows can be rolled up and secured
with the straps.
Step 22) Thee are three zippers on the front wall so
that you can roll up the two sides individually.
ANCHORING YOUR CANOPY
This canopy is designed for use as a temporary structure. After assembly, the canopy MUST BE securely
anchored to the ground to prevent damage from winds. Your canopy will act like a kite in the wind if not
properly and securely anchored to the ground. Severe winds will cause the frame to twist and unanchored
legs will fall, thereby collapsing the canopy. If severe winds are expected, you must remove the cover from
the frame to prevent damage.
Step 1
Measure out at least 36in from each leg. Screw each anchor into the ground leaving 2in between the ground
and the eye of each anchor. We strongly recommend that your unit be anchored 36in from each leg although
this may not be possible in all cases. DO install anchors as close to 36in away from legs as possible.
Step 2
Tie anchor cable or rope around the connector
at the top of each leg of the canopy.This is done
by stringing the rope through the corner grommet
located at each corner on the cover.
Step 3
Securely tie the other end of the cable or rope
through the eye of the anchor and pull tight.
Step 4
Now, continue to screw each anchor into the ground
until the eye of the anchor is flush with the ground.
This will secure the anchor rope even tighter.
Step 5
To secure the side walls insert a ground stake through the
open grommets at the bottom of both side walls.
NOTE: You should check and tighten the rope frequently to
ensure maximum stability of your canopy and to protect
against wind damage.
ANCHOR KIT NOT INCLUDED
WITH THIS CANOPY
