ASSEMBLY
MOUNTING BELT AND DISC SANDER TO WORKBENCH
If the belt and disc sander is to be used in a permanent location, it should be fastened
securely to a firm supporting surface such as a workbench.
If mounting to a workbench, holes should be drilled through supporting surface of the
workbench.
1. The unit should be bolted securely using 5/16" screws and hex nuts (not included).
Screw length should be 1-1/2" plus the thickness of the bench top.
2. Locate and mark the holes where belt and disc sander is to be mounted.
3. Drill (2) 3/8" diameter holes throught workbench.
4. Place belt and disc sander on workbench aligning holes on base with holes drilled
in workbench.
5. Insert two 5/16" screws and tighten hex nuts.
CAUTION
: To avoid injury from tool movement, use 5/16" or larger screws and nuts.
CLAMPING BELT AND DISC SANDER TO WORKBENCH
The belt and disc sander can also be clamped directy to a workbench using two or
more "C" clamps on base of unit (one clamp on each end of unit).
INSTALLING SANDING DISC AND GUARD
1. Remove the disc guard (A) Fig.3 and two pan head screws (B) using a Phillips
screwdriver.
2. Locate sanding disc (A) Fig.4 and peel backing from disc. Align perimeter of disc
with plate and press disc firmly into position all the way around.
3. Reinstall disc guard (B) Fig.4, using a Phillips screwdriver, fasten the pan head
screws (C) securely applying slight pressure to thread the holes.
INSTALLING TABLE ASSEMBLY
1. Locate table assembly (A) Fig.5, washer and lock knob (B) among loose parts.
2. Position table support (C) in the corresponding hole (D) on the side of base.
3. Place washer on threaded shaft of lock knob (B) and insert throught table support,
tighten lock knob to secure table.
WARNING
: To avoid trapping the work or fingers between the table and sanding sur-
face, the table edge should be a maximum of 1/16” from sanding surface.
INSTALLING BACKSTOP
1. Locate backstop (A) Fig.6 and two cap screws and washers (B).
2. Hold work support into position and fasten as shown. Do not overtighten.
WARNING
: To avoid trapping the work or fingers between the backstop and sanding
surface, the backstop edge should be a maximum of 1/16” from sanding surface.
Figure 3
Figure 4
Figure 5
Figure 6
