SPECIFIC SAFETY INSTRUCTIONS
FOR THIS LOG SPLITTER
1) It is obligatory to read the instruction manual in full before using the
log splitter.
2) It is obligatory to wear safety footwear at all times to provide
protection against the risk of logs accidentally falling on feet.
3) It is obligatory, at all times, to wear gloves which protect the hands
against chips and splinters which may be produced during work.
4) It is obligatory, at all times, to wear goggles or a visor which
protects the face against chips and splinters which may be
produced during work.
5) It is forbidden to remove or tamper with the protection devices and
safety devices.
6) It is forbidden to stand in the range of action of the machine, apart
from the operator. No other person or animal may be present
within a radius of 5 meters from the machine.
7) Dumping of used oil in the environment is forbidden. The oil must
be disposed of in accordance to current legislation in the country
where this operation is carried out.
8) Never touch hazardous areas while the wedge is moving. This may
result in cutting or crushing of the hand.
9) Always pay attention to the movement of the log pusher.
10) Never remove a log trapped in the wedge with your hands.
11) Before carrying out any maintenance operation, disconnect the
plug of the machine.
12) The log splitter must always be used by one operator only.
13) Nobody must be allowed to use the log splitter unless they have
read the instruction manual and have been instructed in the
regulations to follow for correct and safe use.
14) The machine must be used by adults only. Use of the log splitter
by apprentices younger than 16 years of age must be supervised
by an adult authorized to use the machine.
15) It is recommended to not work with the machine on the ground.
This is not only an uncomfortable working position but it can also
be dangerous because the operator has to bring his/her face
close to the machine, and thus risks being struck by chips or
debris.
16) Check that the logs to be split are free from nails or wire. The
ends of the logs must be cut square and branches must be cut off
flush with the trunk.
17) Never try to split logs larger than the rated capacity. This could be
dangerous and may damage the machine.
18) Split wood in the direction of the grain. Do not place wood across
the log splitter and leave it in that position for splitting as it is
dangerous and may damage the machine or cause injury to the
operator.
19) Never attempt to cut more than one log at a time as one may fly
up and hit you.
20) Do not attempt to load the log in the log splitter while the ram is
in motion, you could get trapped and injured.
21) Keep your hands well away from any splits and cracks which
open in the log. These may close suddenly and crush or
amputate your fingers.
22) Never force the log splitter for move than 5 seconds keeping the
cylinder under pressure attempting to split excessively hard
wood. After this time interval, the oil under pressure is over-
heated and the machine could be damaged. It is thus better to
stop and rotate the log 90 degrees to see whether it can be split
in a different position. In any case, if you are not able to split the
log, this means that its hardness exceeds the capacity of the
machine and thus the log should be discarded so as to not
damage the log splitter.
23) Do not force the blade by pushing the log on the upper part, as
this can cause the blade to break or damage the body of the
machine. Always set the log on the guides.
