ELECTRICAL INFORMATION
WARNING!
ALL ELECTRICAL CONNECTIONS MUST BE DONE BY A QUALIFIED ELECTRICIAN. FAILURE TO COMPLY MAY RESULT IN
SERIOUS INJURY! ALL ADJUSTMENTS OR REPAIRS MUST BE DONE WITH THE TABLE SAW DISCONNECTED FROM THE
POWER SOURCE. FAILURE TO COMPLY MAY RESULT IN SERIOUS INJURY!
POWER SUPPLY
WARNING:
YOUR TABLE SAW MUST BE CONNECTED TO A 110V, 15-AMP. BRANCH CIRCUIT. FAILURE TO CONNECT IN THIS
WAY CAN RESULT IN INJURY FROM SHOCK OR FIRE.
WARNING:
DO NOT USE A TWO-PRONG ADAPTOR FOR THEY ARE NOT IN ACCORDANCE WITH LOCAL CODES AND
ORDINANCES. NEVER USE IN CANADA.
DOUBLE INSULATION TOOLS
Double Insulation is a design concept used in electric power tools which eliminates the need for the three wire grounded power cord and
grounded power supply system. It is a recognized and approved system by Underwriter’s Laboratories, CSA and Federal OSHA
authorities.
IMPORTANT:
Servicing of a tool with double insulation requires care and knowledge of the system and should be performed only by a
qualified service technician.
WHEN SERVICING, USE ONLY IDENTICAL REPLACEMENT PARTS OR THOSE RECOMMENDED BY THE MANUFACTURER.
RESET BUTTON
This table saw comes with a reset button (next to the power switch). When the table saw motor overheats, a safety mechanism stops the
motor automatically. Press the reset button and restart the table saw. If the table saw does not restart, wait 5 minutes before restarting.
POLARIZED PLUGS
: Your tool is equipped with a polarized plug (one blade is wider than the other), this plug will fit in a polarized outlet
only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the
proper outlet. To reduce the risk of electric shock, do not change the plug in any way.
EXTENSION CORDS
WARNING:
Replace damaged cords immediately. Use of damaged cords can shock, burn or electrocute.
WARNING:
Always use proper extension cord. If an extension cord is necessary, a cord with adequate size conductors should be used to
prevent excessive voltage drop, loss of power or overheating. The table shows the correct size to use, depending on cord length and
nameplate amperage rating of tool If in doubt, use the next heavier gauge. Always use U.L. and CSA listed extension cords.
FIGURE 1
Tool’s
Amperage
Rating
3-6
6-8
8-10
10-12
12-16
Cord Size in A.W.G.
Cord Length in Feet
25 50 100 150
18 16 16 14
18 16 14 12
18 16 14 12
18 16 14 12
14 12
-
-
Wire Sizes in mm2
Cord Length in Meters
15 30 60 120
.75 .75 1.5 2.5
.75 1.0 2.5 4.0
.75 1.0 2.5 4.0
1.0 2.5 4.0
-
-
-
-
-
