ASSEMBLY
8. While holding the rack (A) Fig.10 and table support (B) in an engaged
position, slide both down over the column (C). Slide rack down the col-
umn until the rack is positioned against the lower column support (D).
9. Replace column collar (A) Fig.11 and position it bevel side down over
the rack (B). Tighten set screw (C) in collar with 3mm hex. key (D). To
let the rack slide when the table is swung to the left or right around the
column, the collar must sit loosely over the rack and should not be an-
gled on the column. Only tighten set screw enough to keep the collar
in place, otherwise the collar may break due to excessive pressure.
NOTE: To avoid column or collar damage, do not overtighten set screw.
10. Locate the support lock handle (A) Fig.12 in loose parts bag and
tighten by hand.
11. To minimize crank backlash; tighten the support lock handle and ro-
tate the elevation worm shaft clockwise with the crank handle. Loosen
the set screw in the crank and reposition it as close to the table support
as possible. Tighten set screw in the crank handle.
INSTALLING THE HEAD
1. Remove the protective covering from the head assembly (A) Fig.13A.
2. Carefully lift the head above the column and slide it down on the col-
umn as far as it will go. Align the head with the table and the base.
3. Using a 4mm hex. key, tighten both head set screws (B) on the right
side of the head.
INSTALLING PULLEY COVER KNOB OR LOCKING PULLEY COVER
1. Install the knob (A) Fig.13B to the pulley cover (B) using a small pan
head screw (C) as shown in Option #1, Fig.13B.
2. For safety reasons, user may be required to lock the pulley cover to
prevent easy access to the pulleys. This can be done by only using the
small pan head screw (C). Close the pulley cover and screw pan head
screw through the cover and into the tab (D) as shown in Option #2,
Fig.13B.
FIGURE 10
FIGURE 11
FIGURE 12
FIGURE 13B
FIGURE 13A
